Note:
insert your smart-card in the slit “chip-down”
Humax
Tuner setup. Network Search at 290MHz
1. Press MENU on your remote control.
2. Using vertical arrows, select Installation in the main menu and press OK. If the message «Please enter PIN» appears, enter 0000 or your code.
3. Using vertical arrows, select «Delete settings». Press OK.
4. In Installation menu, using vertical arrows, select «Manual Search» and press OK
5. Using vertical arrows, select Manual Search in the Main Menu and press OK. If you see the box Menu Code. Enter PIN Code, press 0000 or your code.
6. In the Manual Selection menu, set search parameters using vertical arrows to move from one parameter to another.
| Frequency | 290000 (press numbers on the remote control) |
| Symbol Rate | 6875 kS/s (press numbers on the remote control) |
| Const. | 64-QAM or Automatic (select QAM Modulation, then select 64-QAM or Automatic using horizontal arrows) |
| Invert | Automatic or Off (select Inversion, then select Automatic or Off using horizontal arrows) |
| Network | On (select the setting using horizontal arrows) |
The signal is there if you can see the indicators at the bottom of the screen Signal Level and Signal Quality.
7. Press Search.
8. In the menu Manual Search, once channel search is over, in the dialog box Record? press OK.
9. Press the Exit button on the remote control.
10. Make sure the channel list is complete in accordance with your contract.
